Global Leader in Testing Equipment
This tester is made according to CNS requirement, this tester is to do the durability testing by simulating the stroller cross the barricade. The testing method is to put the infant model inside the stroller, raise the stroller to get the back wheels up 150mm from the ground, then press the handle down to get the front wheels up to 150mm from ground, and to do this action with the speed 15cycles/min. After 3000cycles continuous testing, to check the stroller if damage. The tester will automatically stop when reach the set testing cycles.
This baby stroller testing machine is made according to CNS requirement. The test method: to put the infant model inside the stroller, and fix the stroller on the testing table, to adjust the speed to be 83.3m/min or 1.4±0.1m/sec and then running, after 64 hours running testing, to check the stroller if damage.
According to CNS requirement to make the Stroller parking device tester, the test method is to put the stroller with infant model inside on the testing table which is attached with 60# silicon carbide paper, and to adjust the testing table to the needed angle of inclination and keep 30 seconds, to see if the stroller slides or not.
This tester is design according to the standard GB/T9962-1999- 6.11, It satisfys the Architecture laminated glass impact testing requirement.
This tester is used to measure the impact resistance by the specified steel ball at specified hight. It applies for ceramic, acrylic, glass, plastic and etc.
RS-15-200 Declivitous impact test bed simulates impact resistant capacity of product packing in practical condition including handling, shelf stacking, motor slide, lovomotive load, and product transportation etc.