All kinds of portable electronic products such as smart phones, tablet computers, e-books, electronic dictionaries, laptops, MP3 players, game consoles, VR, remote controls, etc, and peripheral products such as chargers, headphones, etc, as well as key parts such sa touch module, glass cover, product shell, camera module, fingerprint module, antenna module, PCBA, soft pack battery, transmitter, receiver, etc due to accidental falling, damage, spontaneous combustion and explosion in the actual use process, the world's major brand manufacturers and parts manufacturers have increased product drop test, and the world has also formulated relevant test standards to standardize the test, such as IEC6006E-2-32, GB/T2423.8, JIS C 60068-2-32, YD/T1539 and other standards.
AS the product needs drop verification test in R&D stage, verification drop test in small-scale trial production stage and spot check drop test after mass production, generally a mobile phone to do at least 500 drop tests from R&D stage to mass production. In addition, each product test to be tested more than 20 times, so the demand for drop test by major manufacturers is also increasing, However, the traditional drop testing machine must be clamped and placed by the operator, and the samples need to be picked up manually after the test. After the test, the operator can only visually detect whether the appearance is damaged, whether the TP module and CCD module are good, and the efficiency is low. And because the operator's operation can not be consistent, the test consistency is very poor, which misleads the R&D team's study.
Instead of manual work, the 6-axis robot it used to complete the loading and unloading of products, pick-up of falling behind, and automatically align the products with the falling sucker or fixture. It can automatically complete 24 kinds of falling ways of edges, comers and surfaces of 10 mobile phones or flat plates.
This machine is a high-tech product integrating artificial intelligence control, automatic test and visual recognition.
IEC60068-2-32 GB/T2423.8《Basic environmental testing procedures part 2:Tests 1 Test Ed: Free fall》;
YD/T1539-2006《Technical Requirements and Testing Methods for Reliability of Mobile Telecommunication Handset》
|Maximum test height||300mm~1800mm or 2000mm|
|Speed error at the end of drop||≤5%|
|Maximum dropping weight||2kg or 3kg|
|Dropping height setting||it is shown on touch screen|
|Minimum releasing height||300mm|
|Product holding mode||Vacuum adsorption or clamp|
|Drop impact surface||Steel plate, Wooden board, Marble board|
|Gas source used||≥0.5Mpa|
|Main unit dimension||W1580xD1150xH2520mm|
|Weight of machine||475kg|
|Power supply||AC 220V 50HZ 3A|